大疆社区

标题: DJI Transcoder无法使用 [打印本页]

作者: Keianster 时间: 2016-12-13
标题: DJI Transcoder无法使用
DJI_Transcoding_Tool_V1.0.0.1207系统是Windows 10 64bit
版本是这个
然后提示如图

或者像老版本一样指定文件名，同样的提示

甚至放到根目录都会有同样的提示

老的版本0.9.2就一切正常。

最后，是否可以增加一下批量处理呢？
一个一个文件去选择实在很麻烦。
多谢！

作者: Keianster 时间: 2016-12-13
Traceback (most recent call last):
  File "transPage.pyc", line 406, in openDialog
UnicodeEncodeError: 'ascii' codec can't encode characters in position 11-13: ordinal not in range(128)
Traceback (most recent call last):
  File "transPage.pyc", line 443, in saveDialog
UnicodeEncodeError: 'ascii' codec can't encode characters in position 11-13: ordinal not in range(128)
Traceback (most recent call last):
  File "transPage.pyc", line 396, in openDialog
UnicodeEncodeError: 'ascii' codec can't encode characters in position 11-13: ordinal not in range(128)
Traceback (most recent call last):
  File "transPage.pyc", line 428, in saveDialog
UnicodeEncodeError: 'ascii' codec can't encode characters in position 11-13: ordinal not in range(128)
Traceback (most recent call last):
  File "transPage.pyc", line 428, in saveDialog
UnicodeEncodeError: 'ascii' codec can't encode characters in position 11-13: ordinal not in range(128)
Traceback (most recent call last):
  File "transPage.pyc", line 428, in saveDialog
UnicodeEncodeError: 'ascii' codec can't encode characters in position 11-13: ordinal not in range(128)
Traceback (most recent call last):
  File "transPage.pyc", line 428, in saveDialog
UnicodeEncodeError: 'ascii' codec can't encode characters in position 11-13: ordinal not in range(128)
Traceback (most recent call last):
  File "transPage.pyc", line 396, in openDialog
UnicodeEncodeError: 'ascii' codec can't encode characters in position 11-13: ordinal not in range(128)
Traceback (most recent call last):
  File "transPage.pyc", line 396, in openDialog
UnicodeEncodeError: 'ascii' codec can't encode characters in position 11-13: ordinal not in range(128)
Traceback (most recent call last):
  File "transPage.pyc", line 428, in saveDialog
UnicodeEncodeError: 'ascii' codec can't encode characters in position 13-17: ordinal not in range(128)

作者: 夏清 时间: 2016-12-14
您尝试把视频放在根目录下，看看能否正常使用呢

欢迎光临大疆社区 (https://bbs.dji.com/)